Table of Contents
Advertisement
3 • Reference
Configuration
Envelopes hit sensor bracket
Right angled
configurations
Relay In line
'Letters'
Material doesn't transport all the way to the stacker end stacking tray
All
All
Material topples over on the belt, even with low numbers of items
All
All
Service
Service for your belt stacker is available throughout the world.
For questions about your belt stacker, or if you require service or
assistance with your application, please call your system supplier..
A service maintenance contract is available to keep your belt Stacker
(as well as your entire Inserting system) in top condition at nominal cost.
Contact Pitney Bowes for details (see the Pitney Bowes Contact List at
start of this guide for contact information).
3-2
Possible Cause
Rear (sensor) guide set too
close to inserter
Adjustable sensor bracket
too close to inserter
Side guides too narrow or
funneled
Step too big, material
slips on belt because of
insufficient weight
Step length too big
Side guides not parallel or
too tight
Remedy
Move rear (sensor) guide back
Pivot sensor bracket slightly
further back
Check side guides are parallel
and have correct clearance
Reduce step, reduce belt speed
Reduce step, reduce belt speed
Check side guides are parallel
and have correct clearance
SV40231 Rev. B
Advertisement
Table of Contents
