Table of Contents
Advertisement
2. The sensor should already be installed
into the slot on the magnetic bracket.
Route the sensor cable back
underneath the nuts attached to the
sensor body and through the cable cut
out on the bracket.
Ensure the bottom face of the sensor
is as close as possible and parallel
to the lower face of the magnetic
bracket.
Make sure the knob (B) is tight.
3. Fit the magnetic bracket (C). Make sure
it locates correctly over the screws (D).
4. Position the stacker against the output
end of the Inserter, centered with
the output. Make sure the stacker is
positioned firmly against the Inserter
covers.
Also make sure the cable (E) is routed
clear of the envelope exit.
5. When positioned correctly, lock all four
castors.
SV40231 Rev. B
Operation • 2
C
D
B
E
2-9
Advertisement
Table of Contents
