Table of Contents
Advertisement
2 • Operation
Setup of In Line mode with Relay Inserters and 'flat' sized
envelopes
The illustration below shows the belt stacker correctly docked to the
Relay Inserter in the In Line orientation running 'flats'.
Follow the steps to correctly set up the stacker:
1. Check the stacker alignment. It should
be level and the height of the stacker
belt should be set to correspond with
the lower mark on the decal installed
to the Inserter exit area. Place a ruler
onto the belt, as shown, to aid the
height setting.
If necessary, loosen the height
adjustment knobs (A) on each leg in
turn and readjust the stacker height.
Alternatively, if the Inserter is on a
height adjustable table, the table can
be adjusted to achieve the correct
height setting.
2-8
A
SV40231 Rev. B
Advertisement
Table of Contents
