Table of Contents
Advertisement
2 • Operation
Operation in In Line mode with the Relay Inserters('flats' sized
envelopes)
1. The stacker side guides will have been locked wide open by your
installing engineer as this configuration does not need the side guides
to control envelope stacking.
2. Read the safety information in this guide, then connect the belt stacker
to the power supply and turn ON.
3. Set the belt speed to maximum.
4. Start the Relay system.
5. Reduce the belt speed until you obtain
the desired envelope overlap.
Keep the overlap as small as possible without envelopes building
up too much. That way you can optimize the belt capacity!
2-10
6
4
2
8
0
10
6
4
2
8
0
10
SV40231 Rev. B
Advertisement
Table of Contents
