Table of Contents
Advertisement
Tandem Belt Stacker
A particular configuration of the stacker is available for the Relay Inserters
that allows automatic stacking of 'Letters' and 'Flats' simultaneously. The
stacker consists of two stacker units mounted onto one set of legs or one
table at the correct vertical spacing to receive 'Letter' and 'Flats' output
from the Inserter.
Use the 'Letters' In Line instructions in this chapter to setup and operate
the top stacker unit. Use the 'Flats' In Line instructions for the lower stacker
unit.
Use of the Belt Stacker with Other Equipment
The belt stacker can be used with equipment other than inserters (for
example, address printers).
Dependent on the equipment being used and the material being run, either
a Right Angled or an In Line configuration will be used.
Full details of your setup will be given by your installing service
representative and will vary in detail based on your application.
However, if you need a reminder, refer to the sections of this guide
covering the Relay Inserters. These sections will describe basic setup and
operation of each configuration.
SV40231 Rev. B
Operation • 2
2-11
Advertisement
Table of Contents
