Table of Contents
Advertisement
2 • Operation
2. Loosen the front and rear end knobs
(B) of the side guide closest to the
inserter output and move the side
guide as far open (in the direction of
the arrow) as it will go.
Retighten the front and rear end
knobs.
3. Check the stacker alignment. The top
of the side guide should fit into the cut-
out on the exit roller bridge assembly.
If necessary, loosen the height
adjustment knobs (C) on each leg in
turn and readjust the stacker height.
Alternatively, if the Inserter is on a
height adjustable table, the table can
be adjusted to achieve the correct
height setting.
4. Position the stacker against the
Inserter, making sure the side guide
fits FULLY into the exit roller bridge
cut-out.
2-2
B
Top of guide fits into
cut-out with minimal gap
SV40231 Rev. B
C
Advertisement
Table of Contents
