Table of Contents
Advertisement
Setup of In Line mode with Relay Inserters and 'letter' sized
envelopes
The illustration below shows the belt stacker correctly docked to the Relay
5000/6000/7000/8000 Inserter in the In Line orientation running 'letters'.
Use of the stacker in this mode allows the
Relay 'Flats' box stacker to remain in use as
shown.
Follow the steps to correctly set up the
stacker:
1. Check that the in line sensor bracket
(A) is installed as shown, using the two
knobs (B) with a spacer between the
bracket and stacker side guide at each
knob position.
Initially, position the sensor at the end
of its slot and pivot the bracket fully
counter-clockwise, as shown by the
arrow.
SV40231 Rev. B
Operation • 2
Flats stacker
A
B
2-5
Advertisement
Table of Contents
