Table of Contents
Advertisement
1 • Product Overview
Control Panel
The stacker is controlled by the control panel. It can be positioned on
either side of the stacker, depending on system configuration.
Change Position of the Control Panel
To change the position of the control panel:
1. Pull the panel firmly towards you to remove it.
2. Refit the control panel to the opening on the opposite side of the belt
stacker.
Power switch
Switches main power
on/off.
How the Belt Stacker Works
The belt starts as soon as the start sensor is covered. When the material
has moved out of the sensor area, the belt stops again.
The Start sensor position is adjustable, allowing the material overlap
•
to be adjusted.
•
The speed of the belt can be adjusted to optimize the stacking
function for various materials.
•
The Run-out button is used to gather the material after a job is
finished. The belt moves at the highest speed, independent of the
Speed selector setting.
1-6
4
6
2
0
10
Speed selector
Sets belt speed.
8
Run-out button
Runs the belt at
full speed - when
you want to gather
the material on the
stacking tray.
SV40231 Rev. C
Advertisement
Table of Contents
