Table of Contents
Advertisement
2 • Operation
2. Check the stacker alignment. It should
be level and the height of the stacker
belt should be set to correspond with
the upper mark on the decal installed
to the Inserter exit area. Place a ruler
onto the belt, as shown, to aid the
height setting.
If necessary, loosen the height
adjustment knobs (C) on each leg in
turn and readjust the stacker height.
Alternatively, if the Inserter is on a
height adjustable table, the table can
be adjusted to achieve the correct
height setting.
3. Position the stacker against the output
end of the Inserter, centered with
the output. Make sure the stacker is
positioned firmly against the Inserter
covers.
4. When positioned correctly, lock all four
castors.
2-6
C
SV40231 Rev. B
Advertisement
Table of Contents
