Operation In Right Angled Mode - Pitney Bowes F680 Operator's Manual

5. When positioned correctly, lock all four
castors.
6. For right hand operation, the sensor
and sensor bracket (D) should be
installed as shown in the picture. Make
sure there is a spacer (E) between the
bracket and stacker side guide at each
knob position.
For left hand operation the parts are
installed mirrored.
Operation in Right Angled mode with Relay Inserters
1. Place one envelope on the belt.
2. Loosen the front and rear end side
guide knobs (A) of the side guide with
the sensor bracket only.
Make sure the side guide rests on
the belt!
3. Adjust the side guide to give a clearance of about 1/8" (3mm) and
retighten the front and rear end side guide knobs.
Make sure the side guides are parallel!
4. Read the safety information on page 1-1, then connect the belt stacker
to the power supply and turn ON.
SV40231 Rev. B
Operation • 2
D
E
1/8" (3mm)
clearance
A
2-3