Setting The Monitor Type At Power On - HP Visualize J5000 Owner's Manual

NOTE

Setting the Monitor Type at Power On

If you replace you computer's monitor with a different monitor type, and
you do not set the computer's graphics parameters by using the monitor
command before doing so, you may need to perform the following if your
screen is blank:
Wait two seconds after the
boot sequence, then press
process.
It takes approximately one to two minutes after powering on the
computer before the
The system cycles through all of the available monitor types one at a
time. When you can see a message similar to the following clearly and
legibly, select the monitor type that will meet your needs by pressing
:
Enter
Path Slot
---------- ----
GRAPHICS(4) 4
Press [Return] to select this monitor type
(type n of n types).
The system queries you to confirm your selection. Press Y to save this
monitor type.
If you press any key other than Y, the following message is displayed:
Monitor type not saved.
At this point, the new monitor type is active, but not saved. Because you
did not save the monitor type, the next time you reboot the system, the
original monitor type will be used.
Chapter 8
Setting the Monitor Type at Power On
light flashes near the end of the
Num Lock
to initiate the automatic monitor selection
Tab
light flashes.
Num Lock
Head Type Size
---- ---- ------------ ----
n nnnnxnnnn
1
The Boot Console Interface
Freq Class
-----
nnHz
151