Loading And Unloading A Cd In The Disk Tray - HP Visualize J5000 Owner's Manual

Using Your CD Drive
Operating the CD Drive

Loading and Unloading a CD in the disk Tray

This subsection describes how to load or unload a CD in the CD drive.
Loading a CD
This CD drive has an automatic loading/ejecting feature. To load a disk
in the CD drive, follow these steps:
1. Check that the workstation is powered on.
2. To open the disk tray, press and release the Eject button on the CD
drive.
3. Hold the disk by the edges with the label side up and place it in the
disk tray.
4. To close the disk tray, push the Eject button again, as it also serves to
close the tray.
Unloading a CD
You must unmount the disk before you eject it from the drive. Unmount
the CD, using either the umount command or the instructions in
"Unmounting a CD Using SAM" on page 98. Perform the following steps
to unload a disk from the CD drive:
1. Press the eject button to eject the disk tray from the drive. If the drive
is in use, you must press the eject button for more than one second to
eject the disk tray.
2. Wait until the drive has fully ejected the disk tray. Remove the disk
from the tray. Be careful to touch only the edges of the disk.
3. To close the disk tray, push the Eject button, as it also serves to close
the tray
92 Chapter 4