HP Visualize J5000 Owner's Manual page 67

3. Remove the filler panels from the DDS/floppy drive bracket by
Figure 2-22 Removing the DDS/Floppy Drive Filler Panels
4. Install the floppy drive into the bracket: the drive itself must be
5. Install the smaller of the two fillers back into the bracket, atop the
Chapter 2
removing the screws and sliding the panels back and then up, as
indicated in the illustration below. Save the larger of the two filler
panels for future use; the smaller of the two will be re-installed after
the floppy drive itself has been installed onto the bracket. Four of the
six screws will be used to secure the floppy drive to the bracket; the
other two screws will be used to re-install the smaller filler panel onto
the bracket.
inserted into the DDS/floppy drive bracket where the larger of the two
fillers had been, and secured by four Torx T-10 screws (two on each
side; the four bottom screws in the illustration above).
floppy drive. Secure it with two remaining screws, and the assembly
should appear as follows.
Changing Your Computer's Hardware Configuration
Floppy Drive Installation
67