Using The Floppy Diskette; Setting The Write-Protect Tab On A Diskette - HP Visualize J5000 Owner's Manual

Figure 6-1
NOTE

Using the Floppy Diskette

This section describes basic information needed for using your floppy
diskettes.

Setting the Write-Protect Tab on a Diskette

You can only store or change information on a diskette when the
write-protect tab is in the write position. So, before trying to write to the
diskette, make sure that the write-protect tab is in the write position, as
shown below.
Setting the Write-Protect Tab on a Floppy Diskette
Push tab up to lock , or
write-protect, the disk.
Push tab down to unlock , or
write-enable, the disk.
To protect files on a diskette from being overwritten, set the
write-protect tab to the write-protect position.
The write-protect tab must be in the write position for formatting a new
diskette and transferring data to a diskette.
Chapter 6
Using Your 3.5-Inch Floppy Disk Drive
Using the Floppy Diskette
115