Table of Contents
Advertisement
Configuration
7.8
Configuration with the graphical user interface (DTM)
7.8.1
System requirements
•
Operating control program (e.g., SMART VISION version 4.01 or higher)
•
DTM (Device Type Manager; graphical user interface)
•
Operating system (depending on the respective control program)
1. The DTM is started in three stages, either using the right mouse button or via the menu item
"Device". First, select "More", followed by "Edit".
2. When you select "Connect" (the third stage), the full transmitter data should be loaded.
Modified data will be underlined in blue.
3. Use "Save to device" to send this data to the device.
IMPORTANT (NOTE)
Saving the data in the transmitter automatically saves it to the non-volatile memory.
For this purpose, the transmitter must remain connected to the supply power for a further two
minutes. Failure to observe this will cause the transmitter to revert to the previous data the
next time it is used.
With PROFIBUS devices, "Local Operation" can only be switched off during cyclical
communication. If write protection is set using the DTM, it will no longer be possible to change
the transmitter setting using the control buttons.
For PROFIBUS devices, the slave address in the user interface project tree must be specified
correctly. The communication name and the description are updated automatically when the
data is loaded from the device.
The most important calibration and parameterization operations within the user interface are
listed in brief below. For additional information on the menu items, refer to the context-sensitive
help. Before making any settings, you must ensure that write protection has not been activated,
whether on the pressure transmitter itself (button with lock symbol) or within the user interface
(menu path: "Configure_Basic Parameters_General_Local Operation").
64
265Gx, 265Ax
IM/265Gx/Ax-EN-07
Advertisement
Table of Contents
