Installing / Removing The Lcd Display - ABB 265GS Operating Instruction

Commissioning
6.6

Installing / Removing the LCD display

1. Unscrew the housing cover of the electronics area (refer to the figure "Securing the housing
cover" in the next section).
IMPORTANT (NOTE)
The optional LCD indicator is designed with type of protection "intrinsic safety" and has been
included for the purpose of the transmitter's EC type-examination certificate.
With an Ex d design, please refer to the section titled "Securing the housing cover with Ex d".
2. Attach the LCD display. Depending on the mounting position of the pressure transmitter, the
LCD display may be attached in four different positions. This enables ±90 ° or ±180 °
rotations.
IMPORTANT (NOTE)
In the case of LCD displays with backlighting (optional), a 3-wire cable with a plug is located at
the rear of the LCD display. Connect this plug to the 3-pin terminal in the electronics area
before attaching the display (see Fig. 15).
3. If the 3-pin terminal strip is equipped with a jumper (fieldbus transmitters do not have
jumpers), remove this and insert it in the "jumper holder".
4. Screw the LCD display in place using the two screws.
5. Retighten the housing cover screws until they are hand-tight.
IMPORTANT (NOTE)
If necessary, refer to the section titled "Securing the housing cover with Ex d".
42 265Gx, 265Ax IM/265Gx/Ax-EN-07