Table of Contents
Advertisement
OX-TRAN Model 2/28 Operator's Manual
Chapter 2: Setting Up
This chapter provides information on how to set up an OX-TRAN Model 2/28 and prepare it for use.
Read this chapter to learn about:
Unpacking the System
•
•
Preparing for System Installation
Front Panel Parts and Controls
•
•
Back Panel Parts and Controls
•
Connecting oxygen and nitrogen gas lines to the instrument
Unpacking the System
Each OX-TRAN Model 2/28 instrument is shipped in its own crate. Any optional kits or accessories may be
shipped in the instrument crate or in separate cartons. A checklist will be included for the instrument and
any of the optional kits you may have purchased.
If any components are missing or damaged please call MOCON in the USA at (763) 493-6370.
Preparing for Installation
The Site Preparation Instructions (Appendix A) contain important information about preparing a location for
the instrument and the facilities required for your new instrument. Please read Appendix A before
proceeding with the installation of the OX-TRAN Model 2/28.
The ambient environmental conditions in which the instrument will be used must meet those specified on
page 8-1 in Chapter 8.
The OX-TRAN Model 2/28 should be placed on a bench or table capable of supporting approximately 43 kg
(95 lbs). The work surface should be flat, clean and free of excessive vibration.
If installing a printer that will be directly connected to the OX-TRAN Model 2/28, place it next to the
instrument. Read the manual that came with the printer for installation procedures.
Do not plug the instrument or printer into a power source until all components have been set up and
connected.
Before proceeding with the setup or operation of the instrument familiarize yourself with the locations and
names of the parts and controls on the front and rear of the instrument.
MOCON, Inc.
Revision J
Setting Up
2-1
Advertisement
Table of Contents
