To Edit Waveforms - Rigol MSQ7054 User Manual

RIGOL

To Edit Waveforms

You can edit the waveforms in the current volatile memory. Press Edit to enter the
waveform editing menu.
Set the frequency or period

First select Frequency or Period, then rotate the multifunction knob
select "Frequency" or "Period". You can also press Frequency or Period
continuously to select it. Also, you can enable the touch screen to select it.
Rotate the multifunction knob
frequency or period value of the current signal.
Set the amplitude or high level

First select Amplitude or High Level, then rotate the multifunction knob
to select "Amplitude" or "High Level". You can also press Amplitude or High
Level continuously to select it. Also, you can enable the touch screen to select it.
Rotate the multifunction knob
amplitude or high level value of the current signal. Note that if you select
"Amplitude" for this menu, then the menu below the Amplitude is
automatically turns out to be "Offset"; if you select "High Level" for this menu,
then the menu below the High Level is automatically turns out to be "Low
Level".
Set the offset and low level

First select Offset or Low Level, then rotate the multifunction knob
select "Offset" or "Low Level". You can also press Offset or Low Level
continuously to select it. Also, you can enable the touch screen to select it.
Rotate the multifunction knob
offset or low level value of the current signal.
Linear Interpolation

Press Linear Interp to enable or disable the linear interpolation between the
defined points of the waveform.
ON: enables the linear interpolation. The waveform editor connects two

defined points by using a straight line.
OFF: disables the linear interpolation. The waveform editor will keep a

constant voltage level between two points and create a ladder-like
waveform.
Edit Points

Press Edit Points to enter the point editing menu. You can specify the voltage
value for each waveform point to define the waveforms.
Current Point

Press PointX, then rotate the multifunction knob
numeric keypad to select the points to be edited. The available range is
from 1 to the number of initial points.
17-12
Chapter 17 Function/Arbitrary Waveform Generator (MSO7000 Option)
or use the pop-up numeric keypad to set the
or use the pop-up numeric keypad to set the
or use the pop-up numeric keypad to set the
or use the pop-up
MSO7000/DS7000 User Guide
to
to