To Create The Waveform - Rigol MSQ7054 User Manual

RIGOL
2. Load the Waveform
Press Load Stored to enter the waveform loading interface. In the disk
management interface, select the waveform from the internal memory or the
external memory. The waveform file is suffixed with "*.arb". Then, press Load
to load the selected waveform. For details, refer to descriptions in "Store and
Load".

To Create the Waveform

You can create arbitrary waveforms according to your needs. Press Create to enter
the waveform creation menu. Meanwhile, the waveform editor is displayed on the
screen.
Set the frequency or period

First select Frequency or Period, then rotate the multifunction knob
select "Frequency" or "Period". You can also press Frequency or Period
continuously to select it. Also, you can enable the touch screen to select it.
Rotate the multifunction knob
frequency or period value of the current signal.
Set the amplitude or high level

First select Amplitude or High Level, then rotate the multifunction knob
to select "Amplitude" or "High Level". You can also press Amplitude or High
Level continuously to select it. Also, you can enable the touch screen to select it.
Rotate the multifunction knob
amplitude or high level value of the current signal. Note that if you select
"Amplitude" for this menu, then the menu below the Amplitude is
automatically turns out to be "Offset"; if you select "High Level" for this menu,
then the menu below the High Level is automatically turns out to be "Low
Level".
Set the offset and low level

First select Offset or Low Level, then rotate the multifunction knob
select "Offset" or "Low Level". You can also press Offset or Low Level
continuously to select it. Also, you can enable the touch screen to select it.
Rotate the multifunction knob
offset or low level value of the current signal.
Set the initial number of points

The initial number of points indicates the number of editable points. By default,
the number of editable points of arbitrary waveforms created can be preset to 2.
Point 1 is fixed at 0 s and Point 2 is fixed at the middle of the period. Press Init
Points, then rotate the multifunction knob
keypad to set the number of editable points for the arbitrary waveform. The
17-10
Chapter 17 Function/Arbitrary Waveform Generator (MSO7000 Option)
or use the pop-up numeric keypad to set the
or use the pop-up numeric keypad to set the
or use the pop-up numeric keypad to set the
or use the pop-up numeric
MSO7000/DS7000 User Guide
to
to