Rigol MSQ7054 User Manual page 242

RIGOL
time, you can view the details in the "Packets" view.
Export: If you select "Packets", you can export time and the

corresponding decoded data. Press Export, the save setting menu is
displayed. You can export the data table of the packets to the internal
or external USB storage device (when detected) in CSV format. For
detailed saving operation, refer to descriptions in "Store and Load".
Jump to: Set the operating status of the oscilloscope to "STOP". Then,

select the data of the specified time from the event table. Press Jump
to and the specified data waveforms are displayed in the center of the
screen.
Decode: The setting of this menu enables you to quickly view the

corresponding event tables of four decode modules (Decode1,
Decode2, Decode3, and Decode4). Press Decode and rotate the
multifunction knob
the knob to select it. You can also press Decode continuously or
enable the touch screen to select it.
6. Interpret the decoded LIN data
Break (Sync Break): expressed in Hex, displayed as a pink patch.

SYNC (Sync): expressed in Hex, displayed in dark yellow-green.

ID (Frame ID): expressed in Hex, displayed in yellow-green.

Data (Data): its display format is the same as that of the bus data (Hex, Dec,

Bin, or ASCII), displayed as a black patch.
CRC (Cyclic Redundancy Check): expressed in Hex, displayed in light

yellow-green. When errors occur, it is displayed as a red patch.
Break
Wakeup (wake up symbol): displayed as a tangerine patch.

7. Error expressions in decoding
In LIN decoding, the parity error, checksum error, or sync error may occur.
Parity Error

If the parity error is detected, frame ID and parity bit (when the signal is set
to include the parity bit) will be displayed in red, as shown in the figure
below.
11-26
to select a decode module, then press down
Sync ID
Chapter 11 Protocol Decoding
Data CRC
MSO7000/DS7000 User Guide