Rigol MSQ7054 User Manual page 72

RIGOL
Label Input Area Input Selection Area Virtual Keypad
Upper-lower
Case Switch
For example, set the label to "
knob to select "Caps" and press down the knob to switch the uppercase or
lowercase mode. Rotate the multifunction knob and select "C", press down the knob.
Then, in the input selection area, rotate the multifunction knob and select "C". Press
down the knob to input "C". Use the same method to input "hn1". After finishing the
input, press OK to finish the editing. You can also enable the touch screen to operate
by touch gestures. If Display is enabled, the label
of CH1 waveform.
To delete or modify the input characters, rotate the multifunction knob
the touch screen to realize it.
Rotate the multifunction knob

characters. To modify the characters, input the desired characters again.
Enable the touch screen: use the touch gestures to directly move the cursor to

the right side of the character required to be deleted or modified, and then tap
the delete key to delete the character. To modify the characters, input the
desired character again or delete the character.
2-12
Figure 2-3 Label Editing Interface
". In the virtual keypad, rotate the multifunction
: use the delete key to delete or modify the
Chapter 2 To Set the Vertical System
Delete Key
will be displayed at the left
MSO7000/DS7000 User Guide
or enable