Tool Length Setting With Stop Screw Setting Adapter With Hex. Back End; Shrinking Capacities - Seco PACKS EASYSHRINK 20 Operating Instructions Manual

8.10 Tool length setting with stop screw setting adapter with hexagonal back end
8.11 Shrinking capability
Minimum height between inductor and flange
location
Maximum height between inductor and flange
location
Flange mounts with fins - height dimension
Stop rod shrink depth capacity
Digital rule stroke
Digital rule display
Tool length setting
Shrinking average type
Minimum shrinking Ø (tool shank)
Maximum shrinking Ø (tool shank)
Open air cooling average time
Ventilator streamed air cooling average time
Ventilator streamed air colling average time by
using air coling pipe with fins
Water cooling average time
Max imum Ø of the tool w ith larger front end than shank
Note:
(1): except SA50 which has a height of 110 mm, hence its stop rod shrink depth capacity 0 to 180 mm.
(2): except Ø 32
Required for adjustment of the stop rod end screw which can be fitted into type
5603 Shrinkfit holders (stop end screws are available as Accessories for type 5603
Shrinkfit holders).
Install the toolholder (with stop screw fitted in) into the finned support. Install the setting
adapter into the toolholder.
Install the cutting tool into the setting adapter.
Set the tool length (taking into account the setting adapter's length from the bottom of
the bore to the back end of the shank : L = 80 mm) by inductor housing pneumatic
actuation, then adjust the requested length with the fine adjustment setting wheel.
Install the control probe of the comparator on the tool top end.
By turning the setting adapter, set the comparator at zero.
Remove tool and setting adapter.
Shrinkfit holder and tool are ready for shrinking.
Pack N°1
60 mm
565 mm
50 mm (1)
0 - 240 mm (1)
600 mm
0,03 mm
590 mm
Shrinkfit holder
type 5800
6 sec.
6 mm
32 mm
25-35 min.
10 min.
3 (2) min.
2 min.
45
Pack N°2 &
Pack N°3
40 mm
545 mm
570 mm
Shrinkfit holder Shrinkfit holder
type 5801 type 5603
2,5 sec. 4 sec.
3 mm 6 mm
16 mm 32 mm
15-25 min. 20-30 min.
5 min. 8 min.
1,5 min. 2 min.
1 min. 1,5 min.
63 mm
Shrinkfit holder
type 5600
6 sec.
6 mm
32 mm
25-35 min.
10-15 min.
3-4 min.
2 min.