Table of Contents
Advertisement
6.6 User guide for shrink-grip of special toolholders
6.7 User guide for shrink-release of special toolholders
Install the two assembled split heat focusing stopper that correspond to the tool shank Ø
(see table § 6.5 on previous page) into the location diameter in the inductor housing.
5 split heat focusing stoppers covering tool shank diameter Ø 3-32 are available as
accessories, capacities : Ø 3-6, Ø 8-14, Ø 16-18, Ø 20-25, Ø 32 mm (see § 1.8.3).
Using the two « ears » flex the lock ring and fit into place to retain the split heat focusing
stopper in the inductor housing. Start the heating cycle as for a standard tool (see § 6.2).
After shrinking remove the lock ring and move the inductor housing downwards,
exposing the split heat focusing stopper. Remove the split heat focusing stopper (caution
– they may be hot).
Move the inductor housing upwards to allow the toolholder to be removed.
Note : Overall height of the inductor housing limits « A » dimension to 70 minimum. Any
less than this and it will not be possible to lower the inductor housing sufficiently to gain
access to the split heat focusing stopper assembly.
Always wear protective gloves while handling Shrinkfit holders, tools,
accessories and spare parts.
Move the inductor housing below the front face of the toolholder and fit the appropriate split
heat focusing stopper assembly around the shank of the cutting tool. Move the inductor
housing upwards so that the split heat focusing stopper seat in the inductor housing location
diameter.
Fit the lock ring.
Start the heating cycle as for a standard tool (see § 6.2).
On completion of the heating cycle move the inductor housing upwards in order to extract
the tool from the toolholder..
38
Advertisement
Table of Contents
