Tool Shrinking Depth Setting; Tool Shrinking Depth To Be Respected; Stop Rod Selection - Seco PACKS EASYSHRINK 20 Operating Instructions Manual

7. TOOL SHRINKING DEPTH SETTING

7.1 Shrinking depth to be respected
Example for an Seco Shrinkfit holder type 5603
The diameter d and the jauge length are indicated
on the toolholder:
E9343 5603 1670
Back end Front end
taper type type
The shrinking depth (depending on the position of the stop end
screw) must be set minimum to l
In this case, the chart indicates l

7.2 Stop rod selection

The proper stop rods in chosen depending on its size B:
Note : When using finned support for Shrinkfit holder taper SA50 (ZFAD05S50), add 60 mm to the value B obtained.
In order to guarantee torque transmission and to increase service life of the
tool, recommended values for shrinking depth must be respected.
Find the minimum shrinking depth from the chart below (also on the device).
Tool
Jauge
diameter
length
.
3
=39 mm.
3
B = A - D
Jauge length (written
on the toolholder)
Shrinking depth
l1 mini < D < l2 maxi
39