Gauging Of The Digital Rule With Display, With Mode Set; Tool Length Setting With Tool Supporting Sleeve For Stop Rod - Seco PACKS EASYSHRINK 20 Operating Instructions Manual

8.8 Gauging of the digital rule with display, with SET mode
SET operation consists in calling up the preset value in PRESET mode (REF I or REF II) into SET mode.
An impulse on BP2 calls up this value.

8.9 Tool length setting with tool supporting sleeve for stop rod

Short indication recalls the
reference choosen
REF I or REF II
These sleeves can be used for locating the cutter onto the stop rod, to free both
hands, when using the direct tool height setting.
Select the suitable stop rod (see § 7.2).
Fit the stop rod into the spindle of the support module shrinking station.
Install the tool supporting sleeve onto the stop rod
Install the cutting tool into the supporting sleeve
Note:
- the top of the stop rod must be in contact with the back end of the cutting tool
- if the cutting tool has a large bore for coolant through it might be necessary to select a
longer stop rod to get into the tool shank.
Set the tool length by inductor housing pneumatic actuation, then adjust the requested
length with the fine adjustment setting wheel.
Install the control probe of the comparator onto the tool top end.
Set the comparator at zero with the setting wheel for stop rod adjustment.
Remove tool and supporting sleeve.
Install the toolholder into the finned support.
Shrinkfit holder and tool are ready for shrinking.
44
Reach stop end of gauge to set
the comparator to 0