Shrinking Depths To Be Respected; Shrinking A Tool Into A Toolholder - Seco EASYSHRINK 15 Operating Instructions Manual

4.3.6. Shrinking depths to be respected

Example for a Seco toolholder type 5603
The diameter d and the jauge length are indicated on the
toolholder:
E9343 5603 1670
Back end Front end
taper type type diameter
The shrinking depth (depending on the position of the stop end
screw) must be set minimum to l
In this case, the chart indicates l
4.4.

Shrinking a tool into a toolholder

Wearing supplied protective gloves is imperative while handling the device and
Note: recommended cylindrical tool shank tolerance is h5 or h6 (maximum h5 for Ø 3 to 5 mm,
maximum h6 for Ø 6 to 32 mm).
1) Move the inductor housing downwards, until the heat focusing stopper enters in contact with the
top of the toolholder.
In order to guarantee torque transmission and to increase service life of the tool, recommended
values for shrinking depth must be respected.
Find the minimum shrinking depth from the chart below (also on the device).
Tool Jauge length
.
3
=39 mm.
3
Shrinkfit holders/tools.
17