Using Programmable Modes Prg1 And Prg2 - Seco PACKS EASYSHRINK 20 Operating Instructions Manual

• Selection of the required mode:
On the control panel, press key
Select the required mode using key
Then press key to confirm your selection
Device is ready for a shrink grip or release heating cycle.

2.8.2 Using programmable modes PRG1 and PRG2

• Heating time modification
In order to prevent misuse of these modes, the modification of the heating times is secured
and an access code is required.
By security measure, heating times of PRG 1 and PRG 2 are preset to 0 second.
The access code and the procedure to modify the heating times are given on request and
after complete information about the risks.
Any change of the preset time must be made carefully, toolholder overheating makes it unusable.
In case of modification without our agreement, Seco Tools AB. cannot be held as responsible for any
damage.
• Selection of the unit mm, inch, or mm and inch with mode PRG 1 or PRG 2:
On the control panel, select mode PRG 1 or PRG 2 (see § above)
Press two times key .
Choose between mm, inch, or mm and inch using key
Press two times key to confirm and come back to working mode.
or (see picture below)
or .
22