Setting The Cooling Times - Seco PACKS EASYSHRINK 20 Operating Instructions Manual

4.5 Setting the cooling times

By default, cooling times are preset to 200 sec. However, these cooling times can be adapted in step with the
cooling system that is used (see table on next page). To do so, coding wheels must be programmed to the
required values.
Cut off every electrical energies.
If you are using a ZFM07MU1 or ZFM07MU2 module (with three-station rotary
support box), you must in a first time remove the rotary plate. If using another
module, directly go to the next page.
Using a 6 mm allen key, unscrew the 3 screws that maintain the rotary plate.
Remove the rotary plate.
28