Table of Contents
Advertisement
PROGRAMMABLE MODES:
control panel.
Mode PRG1: possibility to programm up to 25 customised heating cycles
Mode PRG2: possibility to programm up to 25 customised heating cycles
Seco Shrinkfit holders Code key
E= Monobloc holder
4.3.2. Selection of the heating mode
Selection of the required mode:
•
On the control panel, press key
Select the required mode using key
Then press key
to confirm your selection
Device is ready for a shrink grip or release heating cycle.
4.3.3. Using programmable modes PRG1 and PRG2
Heating time modification
•
In order to prevent misuse of these modes, the modification of the heating times is secured and
an access code is required.
By security measure, heating times of PRG 1 and PRG 2 are preset to 0 second.
The access code and the procedure to modify the heating times are given on request and after
complete information about the risks.
Any change of the preset time must be made carefully, toolholder overheating makes it unusable.
In case of modification without our agreement, Seco Tools AB. cannot be held as responsible for
any damage.
User programms the suitable cycle, in one of the 50 files of modes PRG1 and PRG2, using the
Back end taper type
or
(see picture below)
E 9304 5603 10 120
Front end type
Tool fitting Ø size
14
Gauge length
Advertisement
Table of Contents
