Rxcfg; Tprot - Broadcom 5720ZG User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User's Guide
3. Length (14-65535)
4. Packet Type {Non(0),EthV2(1),802.3(2),SNAP(3)}: Ethernet II
5. Protocol Field {Non(0),IP(1),ARP(2),BRM(3)}
6. Source IP
7. Destination IP
8. IP Protocol Field { UDP(17), TCP(6) }
80. Source Port
81. Destination Port
9. IP Option Length (32-bit Words)
10. TCP Option Length (32-bit Words)
11. Pattern { As-is(0), Inc(1), Random(2), 0s(3), FFs(4),
AA55(5), 55AA(6),IP_Iden-Inc(7),Load from file(8)
00ff8(9) 00ff16(10), 00ff32(11), 00ff(12)}
12. IP Checksum Offload{ YES(1), NO(0) }
13. TCP/UDP Checksum Offload { YES(1), NO(0) }
14. TCP/UDP Pseudo Checksum Only { YES(1), NO(0) }: NO
15. Insert VLAN Tag { YES(1), NO(0) }
16. VLAN Tag
17. Random IP header field { YES(1), NO(0) }
18. Random TCP/UDP header field { YES(1), NO(0) } : NO
0. Exit
Enter your choice (option=paramter) ->

10.76 rxcfg

cmd: rxcfg
Description Configure RX parameters.
Syntax: rxcfg
Example:
0:> rxcfg
1. Host Loopback { Enable(1), Disable(0) }
2. Modify Rx Packet { Enable(1), Disable(0) }
3. Dump Rx Packet { None(1),Hex(2), Decode(3) }
4. Dump Rx Length
5. Tx Fragment Length
6. Tx Flags
7. Tx VLAN Tag
8. Tx Ring Number
9. Tx Generate CRC { Enable(1), Disable(0) }
10. Capture Rx Pacpket { Enable(1), Disable(0) }
11. Rx Mask
0. Exit
Enter your choice (option=paramter) ->

10.77 tprot

cmd: tprot
Description: Blast with TPROT Packets. This command is same as command 'blast -trm'
Syntax: tprot
Options:
page 89
Broadcom Confidential and Proprietary
: 1514
: IP
: 10.2.1.1
: 10.2.1.2
: UDP
: 100
: 200
: 0
: 0
: Increment (00,01,02 ...)
: NO
: NO
: NO
: 1
: NO
: Disable
: Disable
: None
: 64
: 1518
: 0000
: 0000
: 0
: Enable
: Enable