Aspm; Dids; Serial - Broadcom 5720ZG User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User's Guide
Options:
-d
-D
10.197

aspm

cmd: aspm
Description: Configure the PCI-E Link power state operation at the root complex and the
device under test. Power state option described below.
0 ASPM disable
s ASPM L0s enabled
1 ASPM L1 enabled
a ASPM L0s and L1 enabled
Syntax: aspm [-e 0|s|1|a] [-r 0|s|1|a] [-x 0|1] [-d] [-i]
Options:
-r<string> Configure root complex device
-e<string> Configure endpoint (Broadcom) device (dut)
-x<DEC>
-d
-i
10.198

dids

cmd: dids
Description: The feature outputs the following information: PCI DID, VID, SDID &
SVID; MAC address, Firmware revision, PXE, PXESpd, WOL, ASF, MBA, Bond Rev.
This information can be used to verify the setup of a chip after a firmware upgrade.
Syntax: dids
10.199

serial

cmd: serial
Description: Compares the serial number to defaults or the provided values. This PCI
capability testing is only applicable to Shasta C stepping (i.e. BCM5752Cx) family.
Syntax: serial <dwordLo> <dwordHi>
Display Present Size Programmed Into NVRAM
Specify [NVRAM] & [TPM] size in decimal (dflt. hex)
Enable ExtendedSync mode for root complex and endpoint (def=0)
Display present ASPM State
Ignore all previous ASPM setting after a chip reset
page 131
Broadcom Confidential and Proprietary