Pxeprg; Flshdev; Bitbang; Seclock - Broadcom 5720ZG User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User's Guide
-y

10.20 pxeprg

cmd: pxeprg
Description: Program PXE firmware into NVRAM. This command reads PXE code from a
file and program into NVRAM
Syntax: pxeprg <filename>

10.21 flshdev

cmd: flshdev
Description: Select flash device to access
Syntax: flshdev seeprom | atmelflash | sstflash

10.22 bitbang

cmd: bitbang
Description: Generate bitbang pattern to seeprom bus. Enter hex numbers to be written to
seeprom bus. For serial eeprom, use 's' for start, 'p' for stop condition, 'x' with '1..9' specifies
how many residual bits to send. For flash, use 's' for chipSelect, 'p' for cancel chipSelect 'r'
with a number specifies how many bytes to read.
Syntax: bitbang <data>

10.23 seclock

cmd: seclock
Description: set NVRAM config1 content value after reset.
Syntax: seclock <32bitNewValue>

10.24 setorture

cmd: setorture
Description: NVRAM reset torture test
Syntax: setorture
Options:
-c
do not ask for conformation
Continue on Error
page 65
Broadcom Confidential and Proprietary