Installation; Safety - Edwards XDS35iC Instruction Manual

4. Installation

4.1 Safety

WARNING:
Obey the safety instructions in this section and take note of appropriate precautions.
Failure to observe these instructions may result in injury to people and damage to
equipment.
WARNING:
Do not expose any part of the human body to vacuum as it can cause injury.
WARNING:
The pump is not recommended for pumping explosive gases or hazardous
substances.
WARNING:
Use suitable lifting equipment to move the pump. The mass is approximately 48 kg.
WARNING:
Take care when moving the pump into position. The pump's weight makes it difficult
to slide and movement should only be attempted by two people.
▪ A suitably trained and supervised technician must install the pump.
▪ Ensure that the installation technician is familiar with the safety procedures that
relate to the products processed by the pump.
▪ Wear the appropriate safety clothing when coming into contact with contaminated
components.
▪ Dismantle and clean contaminated components inside a fume cupboard.
▪ Vent and purge the vacuum system before starting installation work.
▪ Disconnect other components in the pump from the electrical supply so that they
cannot be operated accidentally.
▪ Refer to the Vacuum Pump and Vacuum System Safety manual (publication
number P40040100) before installing and using the pump to process hazardous or
flammable materials.
▪ Safely route any electrical cables and pipes to prevent a trip hazard.
▪ Check all required components are available and are of the correct type before
starting work.
▪ Do not reuse O‑rings or seals.
A73001880_N
A73001880_N - Installation
Page 17 11/2020 - ©Edwards Limited