Unpack And Inspect; Locate The Pump; Mechanical Fixing - Edwards XDS35iC Instruction Manual

4.3 Unpack and inspect

WARNING:
Use suitable lifting equipment to move the pump. Mechanical equipment should be
attached to the lifting eyes, loose slings should not be used. Failure to do so can
cause injury to people and damage to the equipment. Refer to
mechanical data
Remove all packing materials, remove the pump from its packing box, remove the
protective covers from the inlet and outlet ports and inspect the pump.
If the pump is damaged, notify the supplier and carrier in writing within three days, state
the Item Number of the pump together with the order number and supplier's invoice
number. Retain all packing materials for inspection. Do not use the pump if it is
damaged.
If the pump is not to be used immediately, replace the protective covers. Store the pump
in suitable conditions, as described in
for disposal of materials.

4.4 Locate the pump

WARNING:
Route and secure cables, hoses and pipework during installation to avoid possible
risk of trips.
CAUTION:
If the pump will be located inside an enclosure, ensure there is adequate ventilation
at both ends of the pump, so that the ambient temperature of the pump does not
exceed 40 °C. A minimum space of 25 mm between the pump and the enclosure walls
is required.
Provide a firm, level platform for the pump. Locate the pump so that the gas ballast
control (if fitted) and the Run/Standby switch is accessible.

4.4.1 Mechanical fixing

CAUTION:
Use the four holes located on each corner of the pump base to secure the pump, if
required. We recommend you to use of M8 bolts.
A73001880_N
A73001880_N - Installation
for the mass of the pump.
Storage
Page 20
Table: General
on page 34. Refer to Disposal
11/2020 - ©Edwards Limited
on page 34