Flash Off Time - Datalogic PowerScan 9500 Series Product Reference Manual

References

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in
100 millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad
3. Go to
4. Scan the bar code: SELECT FLASH OFF TIME SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 44. Flash Off Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad
2 with leading zeroes to yield
two digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH OFF TIME SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
284
the result with leading zeroes to yield two digits. For example: 0 = 00,
5 = 05, 20 = 20, etc.
page 75 and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
pad, that represent the duration which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
EXAMPLES
500ms
05
'0' and '5'
Table 44 for some examples of how to
5200ms (5.2
1,000ms (1 sec.)
sec.)
10 52
'1' and '0' '5' and '2'
PowerScan™ PD9530/PBT9500/PM9500
Appendix D, Key-
9,900ms (9.9 sec.)
99
'9' and '9'