Intercode Delay - Datalogic PowerScan 9500 Series Product Reference Manual

References

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0
3. Go to
4. Scan the bar code: SELECT INTERCODE DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-
This completes the procedure. See
set this feature.
Table 36. Wedge Intercode Delay Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
266
= 00, 5 = 05, 20 = 20, etc
page 42 and scan the ENTER/EXIT PROGRAMMING MODE bar code
to enter Programming Mode.
pad, that represent the duration which was determined in the steps
above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
ming Mode.
EXAMPLES
No Delay
00
'0' and '0'
Table 36 for some examples of how to
5 Seconds 60 Seconds
05 60
'0' and '5' '6' and '0'
PowerScan™ PD9530/PBT9500/PM9500
Appendix D, Key-
99 Seconds
99
'9' AND '9'