A1.1.4 Menus - Edwards iXL120N Instruction Manual

A1.1.4 Menus
There are three menu buttons Normal, Status and Setup described below.
NR in the data part of a parameter indicates No Reading.
NP in the data part of a parameter indicates a parameter that is Not Present.
A1.1.4.1 Normal menu
This menu is displayed when the PDT is first plugged into the pump, or accessed by pressing Normal button. Up to 4
parameters displayed, scroll by pressing up/down keys.
Description
Serial Number
Control Holder
Dry Pump current
Dry Pump speed
By default the 4 parameters displayed in the Normal menu are as shown above, these may be changed using Edit
Display attributes menu in SETUP.
A1.1.4.2 Status menu
Press the Status button to enter. Scroll by pressing up/down keys. Press CANCEL to exit back to Normal menu.
If a device is not fitted the associated parameters will not be displayed. Parameters displayed:
Description
Serial Number
Control Holder
Dry Pump current
Green mode
Dry Pump temperature
Dry Pump Power
Dry Pump speed in percent
Dry Pump speed in Hz
Dry Pump inverter temperature
Run Hours
Number of Pump Starts
Time to Stop (seconds)
Active Alarms and Warnings
© Edwards Limited 2010. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Table A3 - Normal menu
Typical Display
S/N 1234567
NONE IN CONTROL
DP CURRENT 4.0 A
DP SPEED 150 Hz
Table A4 - Status menu
Typical display
S/N 1234567
NONE IN CONTROL
DP CURRENT
GREEN MODE
DP TEMP
DP POWER
DP SPEED
DP SPEED
DP INV TMP
RUN HOURS
PUMP STARTS
TIME TO STOP
A541-11-880 Issue A
4.0 A
Off
100 °C
0.52 kW
100%
150 Hz
100 °C
1000
100
900
Page 43