Removing The Ixl120 System From The Packaging - Edwards iXL120N Instruction Manual

A541-11-880 Issue A
3.2

Removing the iXL120 system from the packaging

You must use suitable lifting equipment to move the system. It is too heavy to lift by hand.
Do not exceed the topple angle of 10° when moving the pump. Wheel the system on its castors to
move it into its operating position. The system should only be wheeled short distances over flat
surfaces. If the floor surface is uneven or has obstacles the system should be lifted with suitable
lifting equipment.
1. Cut open bag and expose
the brackets which are used
to fasten the pump to the
pallet.
3. Remove the brackets from
the pump.
5. Lift pump using suitable
lifting equipment, as
shown.
7. Lower pump to ground and
remove lifting brackets. If
stacking pumps then leave
these brackets in place and
refer to section 3.4.
9. The iXL120 system is ready
to be located; please refer
to Section 3.3 of the
manual.
Page 14
WARNING
WARNING
2. Remove the fasteners at the
brackets securing the pump
to the pallet.
4. Reattach the brackets at
the top front right and top
rear left corners using 2
fixings for each bracket.
6. Wind up jacking feet until
flush with bottom of chassis
to expose the castors to
allow the pump to be
manoeuvred.
8. Store the brackets under
pump frame for later use.
© Edwards Limited 2010. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.