Dial In Load/Dial Out Load - Sam4s ER-900 Series Operator's And Programming Manual

Dial In Load/Dial Out Load

These functions apply only to legacy DataTran equipment. Perform if instructed by Datacap
support. You will be required to enter the phone number and terminal I.D.
Z-Mode: Enter 508, press SBTL (Dial In Load)
Z-Mode: Enter 509, press SBTL (Dial Out Load)
DataTran NoLoad/AutoLoad Notes/TwinTran
NoLoad
Parameters managed at the processor host, not in the DataTran. For installation, changes,
exchanges, call the processor, tell them the unique "mac" id, run tests and begin operations.
AutoLoad
Parameters managed on PSCS, Datacap's web-based load system. Parameters are
downloaded to the DataTran upon first use and for reloads on demand.
TwinTran
When a TwinTran is first installed, the dealer must do a Dial Out Load through the IP
connection. If, for any reason, the internet is not available, the device cannot be loaded. If it
is being installed at a location where the Internet is not currently operational and the
customer wants to use the dial out method for approvals, the procedure below must be done
at a location where the internet is working.
To load a TwinTran using a Sam4s register;
With the TwinTran connected to the register and an active Ethernet line, enter into the Dial
Out mode. At the Phone number field enter the number "1". If the register uses the code
entry method for alpha characters enter the 3-digit code (049). At the Enter ID prompt, enter
the serial number of the TwinTran. Select Tone phone connection. The TwinTran will call
DataCap's host PC and load itself. This takes approximately 20 seconds. After the TwinTran
is loaded, one successful credit transaction must be done. After that the unit can be connected
as the customer wishes.
SAM4s ER-900 Series Operator's & Programming Manual v.1.39 Integrated Payment Appendix • 237