Issue Local Batch Status Report; Enable Dial In Load/Enable Dial Out Load - Sam4s SPS-500 Operator's Manual

Issue Local Batch Status Report

The Local Batch Status Report also prints when a batch is closed.
See Explanations
Local Batch Status Explanations:
(From Left to Right)
C Batch Status C=Closed/O=Open/X=Incomplete
1 Batch Number
2 Batch Transaction Count
2 Batch Item Count
5.00 Batch Balance
2 Batch Forwarded Transaction Count
5.00 Batch Forwarded Balance

Enable Dial In Load/Enable Dial Out Load

For Legacy DataTran equipment:
If instructed by Datacap support, you can use these options to update DataTran software. Choose Enable Dial
In Load to allow Datacap to call the DataTran and send updates. Choose Enable Dial Out Load to call
Datacap to connect. You will be required to enter the phone number and terminal I.D. which will be given to
you by DataCap.
For TwinTran:
When a TwinTran is first installed, the dealer must do a Dial Out Load through the IP connection. If, for
any reason, the internet is not available, the device cannot be loaded. If it is being installed at a location where
the Internet is not currently operational and the customer wants to use the dial out method for approvals, the
procedure below must be done at a location where the internet is working.
To load a TwinTran using a Sam4s register;
With the TwinTran connected to the register and an active Ethernet line, enter into the Dial Out mode. At the
Phone number field enter the number "1". At the Enter ID prompt, enter the serial number of the TwinTran.
Select Tone phone connection. The TwinTran will call DataCaps host PC and load itself. This takes
approximately 20 seconds. After the TwinTran is loaded, one successful credit transaction must be done.
After that the unit can be connected as the customer wishes.
104  Reports
DATE 6/17/2009
**** LOCAL BATCH STATUS ****
C 1 2 2 5.00 2 5.00
NO.000011 REG01 EMPLOYEE1
MON
TIME 11:07
SAM4s SPS-500 Operator Manual v1.2