Operating The Parking Brake; Starting The Engine - Toro Field Pro 604 Operator's Manual

Operating the Parking
Brake
Figure 26
1. Parking brake engaged
•
Pull the parking brake handle to engage the
parking brake (Figure
•
Push the parking brake handle to disengage the
parking brake.

Starting the Engine

Important:
Do not engage starter for more than 5
seconds at a time. If the engine fails to start, wait
15 seconds between attempts. Failure to follow
these instructions can burn out the starter motor.
Note:
You may need multiple attempts to start the
engine the first time after adding fuel to an empty fuel
system.
1. Move the motion-control bars to the N
position.
2. Engage the parking brake.
3. Move the throttle midway between the S
and F positions
AST
2. Parking brake disengaged
26).
EUTRAL
LOW
(Figure 27).
1. Throttle—midway position
2. Choke—O
N
4. If the engine is cold, pull the choke control to the
O position
N
Note:
When operating the machine in
g333764
temperatures less than 0°C (32°F) allow the
engine time to warm up before using the
machine. This prevents damage to the hydraulic
system.
5. Rotate the ignition key to the S
(Figure 27).
Note:
To prevent overheating the starter
motor, do not engage the starter longer than
10 seconds. After continuous cranking the
starter for 10 seconds, wait 60 seconds before
engaging the starter motor again.
6. When the engine starts, rotate the key to the
R position
UN
7. Move the throttle to the S
the engine to warm.
8. As the engine warms up, push the choke control
toward the O
23
Figure 27
3. Ignition key—S
4. Ignition key—R
(Figure 27).
TART
(Figure 27).
position, and allow
LOW
position (Figure 27).
FF
g384035
TART
UN
position