Table of Contents
Advertisement
Lifting the Machine
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious injury.
Use jack stands when supporting the
machine.
1.
Raise the mid-mount attachment and optional
rear attachment.
2.
Park the machine on a level surface; engage the
parking brake; shut off the engine; remove the
key; and wait for all movement to stop before
leaving the machine.
3.
If attached, remove the optional rear attachment
4.
Raise the machine using the designated jacking
points as follows:
•
Front—center of the front caster wheel axle
as shown in
Figure
WARNING
The front axle can pivot; ensure that
the floor jack is centered on the
machine so that it does not shift while
lifting; always use 2 jack stands to
support the machine once it is lifted.
Figure 69
1. Floor jack centered on the
axle.
2. Front jack point; do not
allow the jack to contact
the grease fitting.
•
Left and right sides—under the rear tube of
the frame assembly behind the wheel motors
(Figure
70).
69.
g396208
3. Jack stands placed on
both sides of the front axle
plate.
1. Floor jack
2. Rear jack point; floor jack
under the rear tube of the
frame assembly.
47
Figure 70
3. Rear tube of the frame
assembly.
4. Jack stands placed under
the far ends of the rear
tube of the frame.
g396207
Advertisement
Table of Contents
