Table of Contents
Advertisement
2.
Connect the bottom of the long rear-lift chains to
the hanger tube at the bottom of the lift frame
using flange-head bolts (3/8 x 1-3/4 inches),
washers (2/5 inch), and flange locknuts (3/8
inches) as shown in
Figure 10
1. Flange locknut (3/8 inches) 4. Hanger tube
2. Long rear-lift chain
3. Washer (2/5 inch)
3.
Align the rear attachment lift frame under the
machine
(Figure
11).
Note:
Ensure that the rear attachment lift frame
is centered under the machine.
Figure 11
Figure
10.
5. Flange-head bolt (3/8 x
1-3/4 inches)
4.
Lift the back of the rear attachment lift frame to
align the holes in the lift-frame tubes with the
holes in the channels of the rear frame
12).
g392425
1. Flange locknut (1/2 inch)
2. Tube (rear attachment lift
frame)
Note:
Install the hardware with the bolt heads
toward the outside of the machine.
5.
Assemble the 6 flange-head bolts (1/2 x 3
inches) through the holes in the channels and
the tubes.
6.
Assemble the 6 flange locknuts (1/2 inch) onto
the flange-head bolts.
7.
Torque the flange-head bolts and locknuts to 91
to 113 N∙m (67 to 83 ft-lb).
g361712
13
Figure 12
3. Flange-head bolt (1/2 x 3
inches)
4. Channel (rear frame)
(Figure
g392387
Advertisement
Table of Contents
