Table of Contents
Advertisement
Figure 73
Mid-mount Attachment Tilt Cylinder
1. Grease fitting
Figure 74
Rear Attachment Lift Cylinder
1. Grease fitting
g366693
2. Mid-mount attachment tilt
cylinder
g385703
2. Rear attachment lift
cylinder
Engine Maintenance
Engine Safety
•
Shut off the engine before checking the oil or
adding oil to the crankcase.
•
Do not change the governor speed or overspeed
the engine.
Engine Oil Specification
Use high-quality engine oil that meets the following
specifications:
API classification level: SJ or higher
Oil Viscosity: SAE 30—above 4°C (40°F)
Checking the Engine-Oil
Level
Service Interval: Before each use or daily
Note:
The engine is shipped with oil in the crankcase;
however, you must check the oil level before and after
you first start the engine.
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2.
Remove the hood; refer to
(page
45).
3.
Clean around the dipstick and dipstick tube.
4.
Remove the dipstick
a clean rag.
1. Dipstick (engine oil)
5.
Insert the dipstick into the tube
it is fully seated.
49
44).
Removing the Hood
(Figure
75) and wipe it with
Figure 75
(Figure
g333929
75) until
Advertisement
Table of Contents
