Table of Contents
Advertisement
3.
Connect the rear attachment adapter assembly
to the drawbar with a hex-head bolt (3/4 x 3-1/2
inches), flat washer, and a locknut (3/4 inch) as
shown in
Figure
8.
Note:
Install the screw through the rearmost
hole in the adapter assembly and drawbar.
Figure 8
1. Install the attachment adapter here.
4.
Install the lift chains to the lift-bar assembly with
flange-head bolts (3/8 x 1-3/4 inches), washers
(3/8 inch), and locknuts (3/8 inch).
5.
Slide the chain sleeves onto the lift chains,
and then install the lift chains to the shaft-lift
assembly with shackles, clevis pins, and cotter
pins.
Assembling the Lift Frame to the
Machine
1.
Connect the second link of the long rear-lift
chains to the top of the lift frame using shackles,
clevis pins, and cotter pins
g383945
1. Shackle
2. Long rear-lift chain
(second link)
3. Align the shackle and
chain with the hole in the
lift frame
12
(Figure
9).
Figure 9
4. Clevis pin
5. Cotter pin
6. Lift frame
g392426
Advertisement
Table of Contents
