Table of Contents
Advertisement
Assembling the Rear Attachment
Lift Cylinder
1.
Remove the cable tie that secures the rear
hydraulic cylinder and hoses to the back of the
machine.
2.
Remove the carriage bolt and flange locknut
that secures the cylinder pin to the lift-shaft arm
(Figure
16).
Figure 16
1. Carriage bolt
2. Lift-shaft arm
3.
Route the cylinder and hoses to the back of the
lift frame
(Figure
4.
Install the hose guard around the hoses 9 cm
(3.5 inches) from the rear tube channel as
shown in
Figure
Note:
Ensure that the extend and retract hoses
are not twisted around each other.
Figure 17
1. 9 cm (3.5 inches) from
the end of the rear tube
channel.
5.
Assemble the rear attachment lift cylinder onto
the mount shaft of the rear frame
3. Cylinder pin
4. Flange locknut
17).
17.
2. Hose guard
(Figure
g361587
1. Attachment-lift cylinder
6.
Align the rod end of the cylinder between the
lift-shaft arms
1. Carriage bolt
2. Flange locknut
3. Rod end (attachment-lift
g361588
cylinder)
7.
Secure the rod end to the lift-shaft arms with the
cylinder pin, carriage bolt, and flange locknut.
8.
Lower the operator's platform.
Note:
18).
is fully extended, the drawbar should be fully
raised against the rubber bumper.
15
Figure 18
2. Mount shaft (rear frame)
(Figure
19).
Figure 19
4. Lift-shaft arm
5. Cylinder pin
When the rear attachment-lift cylinder
g374125
g374126
Advertisement
Table of Contents
