Table of Contents
Advertisement
8.
Align the hole in the rod end of the drawbar with
the holes in the drawbar mount of the rear-frame
bulkhead
(Figure
1. Locknut (3/4 inch)
2. Rod end (drawbar)
3. Drawbar mount
(rear-frame bulkhead)
9.
Assemble the rod end to the mount with the
capscrew (3/4 x 4-1/2 inches), 2 spacer, and
locknut (3/4 inch) as shown in
10.
Torque the capscrew and locknut to 320 to 396
N∙m (238 to 392 ft-lb).
Assembling the Drawbar Chains
to the Lift Frame
1.
Cross the attached chains from the
over the drawbar.
1. Short drawbar chain
(17-1/2 inches)
2. Flange-head bolt (5/16 x
1 inch)
3. Washer (3/8 x 7/8 inch)
2.
Pull the slack from the chain and align the link
to the hole in the tow-stop bracket of the of the
drawbar.
13).
Figure 13
4. Capscrew (3/4 x 4-1/2
inches)
5. Spacers
Figure
13.
(Figure
Figure 14
4. Flange locknut (5/16 inch)
5. Tow-stop bracket
(drawbar)
Ensure the link is flush to the outboard side of
the bracket, and the next link forward aligns into
the groove in the bracket.
3.
Assemble the chain to the stop bracket with a
flange-head bolt (5/16 x 1 inch), washer (3/8
x 7/8 inch), and flange locknut (5/16 inch) as
shown in
4.
Repeat steps
the other side of the stop bracket.
5.
Where the chains cross
them with a flange-head bolt (3/8 x 1-1/2 inches)
and flange locknut (3/8 inch).
g361586
1. Flange locknut (3/8 inch)
2. Connect the chains
through the 6th link from
the tow-stop bracket on
each chain
14)
6.
Torque the 5/16 inch flange-head bolts and
locknuts to 19.8 to 25.4 N∙m (175 to 225 in-lb).
7.
Torque the 3/8 flange-head bolt and locknut to
37 to 45 N∙m (27 to 33 ft-lb).
g392371
14
Figure
14.
1
through
3
for the other chain at
(Figure
Figure 15
3. Flange-head bolt (3/8 x
1-1/2 inches)
4. Short drawbar chains
15), assemble
g392382
Advertisement
Table of Contents
