Toro Field Pro 604 Operator's Manual page 33

Using the Attachment Stop During
Operation
1. If needed, calibrate the mid-mount attachment
stop to grade; refer to
Attachment Stop (page
2. Move the machine to a level surface at the job
site, and engage the parking brake.
3. Lower the mid-mount attachment
Height of the Mid-Mount Attachment (page
4. If used, insert a stop pin into the up-stop
attachment-stop hole; refer to
Positions (page 31).
5. If used, raise the mid-mount attachment as
needed and insert a stop pin into one of the
following attachment-stop holes:
•
Above-grade attachment-stop hole
46)
Figure 46
•
Grade- or below-grade attachment-stop hole
(Figure 47)
Calibrating Mid-Mount
35).
Adjusting the
26).
Up-Stop Stop-Pin
(Figure
g384283
6. Raise or lower the mid-mount attachment until
the attachment stop contacts the stop pin.
33
Figure 47
g384284