Calibrating Mid-Mount
Attachment Stop
This procedure adjusts ground level reference point
for the attachment stop.
Preparing the Machine
Optional Mid-Mount Grader
Operator supplied: 2 wood blocks 38 mm (1-1/2
inches) thick
1.
Move the machine to a level surface and engage
the parking brake.
2.
If inserted remove the stop pins from the
following mid-mount attachment stop positions:
•
Transport and maintenance position
attachment-stop hole
•
Up-stop attachment-stop hole
•
Grade- or below-grade attachment-stop hole
•
Above-grade attachment-stop hole
Figure 49
3.
Fully raise the mid-mount attachment; refer to
Raising the Mid-Mount Attachment (page
4.
Tilt the multi-tool carrier backward
until the tines are aligned higher that the bottom
of the grader blade; refer to
Attachment Forward (page
g384311
35
(Figure
Tilting the Mid-Mount
27).
Figure 50
26).
50)
g365617