Toro Field Pro 604 Operator's Manual page 41

1. Full-width ramp in stowed
position
2. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
Loading the Machine
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death.
• Use extreme caution when operating a
machine on a ramp.
• Back the machine up the ramp and walk it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
1. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2. If applicable, connect the trailer brakes and
lights.
Figure 59
3. H=height of the trailer or
truck bed to the ground
4. Trailer
3. Lower the ramp
4. If installed, fully raise the mid-mount attachment
and optional rear attachment.
5. Back the machine up the ramp
1. Back the machine up the
ramp.
6. Fully lower the mid-mount attachment and
optional rear attachment.
7. Shut off the engine, remove the key, and engage
the parking brake.
8. Tie down the machine at the front frame and the
rear-attachment frame
chains, cable, or ropes.
g337406
Note:
Refer to local regulations for tie-down
requirements.
41
(Figure 59).
(Figure
Figure 60
2. Drive the machine down
the ramp.
(Figure 61) with straps,
Figure 61
60).
g337358
g386309